Cosari TrailLock Pro

Features

Locks at Both Ends

Two 6061-T6 aluminum collars clamp a rigid inner core to your 22.2mm bar with stainless 3mm bolts. Water and sweat can't make it rotate.

Spreads Palm Pressure

The 32mm swell fills the outer edge of your hand, so weight spreads over a wider area instead of pinching the nerve that numbs your fingers.

Shields the Bar End

When the bike goes down, the outer aluminum collar and sealed plug take the hit, protecting the rubber, the bar tip, and your brake lever.

• Damps Trail Chatter

  Thick 45A Kraton rubber absorbs the high-frequency buzz from roots and brake bumps that causes arm pump and tingling fingers.

• Installs in 180 Seconds

  Slide on, rotate the palm swell to your wrist angle, and tighten four bolts with a 3mm key. Removal takes the same tool.

• Grips in Mud and Rain

  The gecko micro-tread drains water and holds your fingers on wet descents, with or without gloves.

• 32mm Ergonomic Palm Swell

  A wider contour supports the outer edge of your palm, taking pressure off the ulnar nerve that causes pinky and ring-finger numbness.

• Gecko-Pattern Kraton Tread

  45A Shore rubber with directional micro-tread holds your fingers in rain and sweat, gloved or bare-handed, without feeling gummy.

• Sealed Bar-End Protection

  The outer metal collar and flush weather-sealed plug take rock scrapes and keep mud out of your bar tip.

How to use it

1. 1

   Slide On

   Remove your old grips and slide the TrailLock Pro onto the bare 22.2mm bar. No glue, hairspray, or air needed.

2. 2

   Align & Tighten

   Rotate the palm swell to match your wrist angle, then tighten the inner and outer collar bolts with a 3mm Allen key.

3. 3

   Ride

   Hit your roughest trail. The grips stay locked in place and your fingers stay light on the brakes.