Cosari BassStage-XLR

Features

Dial In Warmth Without Losing the Bottom

Set Drive for grit, then use Blend to bring back your clean signal. Around 10 o'clock on Blend gives a warm, chewy tone with the full low end still there. Shape it with Bass, Mid and Treble.

Send a Quiet, Balanced Feed to the Board

Plug any standard XLR cable into the output. If you hear hum, flip GND LIFT. Flip CAB SIM for a mic'd-cabinet sound. Both toggles are recessed so they stay where you set them.

Split Your Signal Two Ways

The XLR carries your shaped tone to FOH or your interface. The parallel 1/4-inch thru sends a clean, dry copy to your tuner, stage amp or monitor wedge.

• CNC Aluminum, Not Plastic

  A 6061 aluminum chassis with 2.2mm walls, metal-nut jacks, a locking XLR and recessed toggles. It weighs 410 grams and feels solid under a boot.

• Two Outputs, One Pedal

  Send your shaped tone to the board over XLR and a clean dry signal to your amp or tuner from the parallel thru, at the same time.

• Balanced XLR + Ground Lift

  A 600 Ohm gold-plated XLR with phantom power protection and a -98dBu noise floor. One flip of GND LIFT kills ground-loop hum.

• Analog 4x10 Cab Sim

  Switch it on and the direct feed sounds like a mic'd 4x10 cabinet, with the harsh clank above roughly 4.5kHz rolled off before it hits the PA horns.

• Active 3-Band EQ

  +/-12dB at 80Hz for weight, 500Hz for punch and 3.2kHz for attack. A small mid boost gets you through two loud guitarists.

How to use it

1. 1

   Power & Plug In

   Connect a 9V DC center-negative supply and run your bass cable into the INPUT jack.

2. 2

   Connect the XLR

   Click an XLR cable into XLR OUT and run it to the board or your interface. Flip CAB SIM on, and GND LIFT if you hear hum.

3. 3

   Dial It In

   Start with Blend at 10 o'clock and Drive at 11, then shape it with Bass, Mid and Treble. Set Level and play.