
Does exactly what I needed
Installed this on my tractor since it sometimes sits for weeks between uses. It completely cuts off the parasitic drain when I'm done. Performs exactly as advertised. I'd buy it again!
Quarter-turn off. Zero battery drain.

Clamp it onto your negative post, move your factory cable to the side post, and turn the red handle when.
Claim 50% Off — Order NowIn Stock – Free 5–7 Day US Shipping

The pickup that only hauls on weekends, the camper in the side yard, the boat on the trailer. Here's how the VoltLock T1 keeps them ready to start.
A wide handle you can grab with gloves on. Turn it 90 degrees over the blue ON/OFF plate and it stops firmly at each end.
A bolted clamp grips the battery post while a cast side post takes your factory cable at a natural angle. No bending, no cutting.
In our testing, the switch fully opened the ground circuit against a 140mA draw. After 21 days parked, the battery still read 12.68V.
Internal copper contacts carry 250A continuously and handle starter surges up to 1000A, with under 0.04V of drop in our V8 tests.

The bolted silver clamp tightens onto your battery's negative post. Your original negative cable clamps onto the cast silver side post. Nothing in your wiring changes.

Turn the red T-handle 90 degrees to OFF and the ground path is broken. Turn it back to ON and full starting current flows again.

A fiberglass-reinforced housing, heavy hex bolts, and a solid metal bridge carry current without heating up, through vibration and heat cycles under the hood.

Limited-Time Direct Offer — Save 50% Today
Top-Post Battery Cutoff Switch | 12V–48V DC | 250A Continuous / 1000A Cranking
Backed by our 30-Day Money-Back Trial & Full Cosari Guarantee.
$29.99 $59.99 Free Tracked Shipping (5–7 Days) Included
In Stock: Delivers in 5–7 Business Days. Free insured US delivery with tracking.
30-Day Money-Back Guarantee plus a full 2-Year Warranty.
Quantity
Description: The Cosari VoltLock T1 is a clamp-on battery disconnect switch for standard negative top posts. It stops parasitic drain in vehicles that sit for weeks: pickups, classic cars, RVs, boats, mowers, and tractors. A quarter-turn of the red T-handle disconnects the battery. Another quarter-turn brings it back.
Fitment: Fits standard tapered negative top posts, roughly 15.5mm to 17mm. Overall length is about 5.3 inches and height to the top of the handle is about 2.9 inches. Allow around 2.5 inches of clearance around the post. Not for side-post or stud-terminal batteries.
Shipping & Guarantee: Free tracked shipping on every order. Try it for 30 days. If it doesn't fit your battery or doesn't hold your charge, return it for a full refund. Covered by a 2-year replacement warranty.
Free 5–7 Day US Shipping: Every order ships free with full tracking and delivers in 5 to 7 business days.
30-Day Trial: Try it at home for 30 days risk-free. Need help? Email us anytime at support@buycosari.com.
2-Year Warranty: If anything goes wrong within 2 years, we replace it free of charge or refund your order in full.

Your original negative cable stays exactly as it came from the factory. It just clamps onto the switch's side post instead of the battery.
Back out one Phillips screw and the red handle lifts off. With the switch OFF, the vehicle won't crank.
A sealed fiberglass-reinforced housing and heavy hardware handle engine-bay temperatures from -20°F to 180°F.
Cosari VoltLock T1Standard Competitors
| Feature | Cosari VoltLock T1 | Standard Competitors |
|---|---|---|
| Turning it off | One quarter-turn of a large handle | Several full turns of a small screw wheel |
| Installation | Clamps on with one 10mm wrench | Often needs cable cutting and new lugs |
| Clamp strength | Thick jaws and heavy hex bolts | Thin cast clamps that can crack when tightened |
| Starter current | 1000A surge, under 0.04V drop in testing | Can heat up and drop voltage while cranking |
| Theft deterrent | Removable handle | None |

Swipe left for steps 2 and 3

Remove your negative cable, then tighten the switch's silver clamp onto the battery's negative post with a 10mm wrench.

Clamp your original negative cable onto the switch's cast silver side post. No cutting or crimping.

Give the red handle a quarter-turn to OFF. Your battery is fully disconnected until you turn it back on.

Installed this on my tractor since it sometimes sits for weeks between uses. It completely cuts off the parasitic drain when I'm done. Performs exactly as advertised. I'd buy it again!

Bought this six months back. It's a simple red T-handle on a black block with a cast post and terminal clamp. Ten bucks, does the job, no complaints.
Feels pretty sturdy for the price. The silver terminal clamp has some heft, the hex bolts on the black base are solid, and the red knob has a firm quarter-turn.
—UPDATE: I bought one and it's awesome. Clamped it to the battery post, attached the car's cable to the side silver post, and tried a few ON/OFF turns. Left the car parked two weeks and had zero battery drain.
Best $10 you'll ever spend. It kept my $180 RV battery from dying over the winter, and I don't have to grab a 10mm wrench to unbolt the negative cable every time.
100%. Fantastic bit of kit considering they are so cheap and so effective. My older truck had a mystery electrical leak, and a quick twist of the red handle stops it draining the battery while parked.
It's the best and most affective! The red rotary knob cuts power cleanly, and the blue ON/OFF indicator plate makes it easy to see which way I'm turning it.
I put this exact black-and-red top-post cutoff on my weekend cruiser a few years ago. Been using it at least weekly since then, and it's held up great. No corrosion or loose contacts so far. Highly recommend.
The offset L shape worked nicely on my battery. The bolted silver clamp goes directly on the battery post, and the cast dummy post sits to the left. My original cable clamp went straight onto it without cutting any factory wires.
The blue ON/OFF arrows under the red T-handle are easy to read. The handle comes off by removing the center Phillips screw, so I can take it with me as a little extra theft deterrent when parking in public.
$29.99 $59.99 Free Tracked Shipping (5–7 Days) Included
In Stock – Free 5–7 Day US Shipping · 30-Day Risk-Free Trial.
It's made for standard tapered negative top posts, roughly 15.5mm to 17mm. It won't fit side-post or threaded-stud batteries. Allow about 2.5 inches of clearance around the post, 5.3 inches of overall length, and 2.9 inches of height to the top of the handle.
No. The switch clamps onto your negative post, and your existing negative cable clamps onto the switch's side post. One 10mm wrench is usually all you need.
It's rated for 250A continuous and a 1000A cranking surge. On our 5.3L V8, it passed roughly 450-amp cranks with under 0.04V of drop.
12V to 48V DC systems, which covers cars, trucks, RVs, boats, mowers, and tractors.
Yes. Remove the Phillips screw on top of the red handle and lift it off. With the switch OFF and the handle in your pocket, the vehicle won't crank.
You have 30 days to try it. If it doesn't fit your battery cleanly or doesn't hold your charge, send it back for a full refund. It's also covered by a 2-year replacement warranty.